Model Wedge from the Pb With height h Wedge angle a °
PH 1.6 3 40
PJ 2.34 4 40
PK 3.56 6 40
PL 4.7 10 40
PM 9.4 17 40
Ribbed products in the raw materials used
The neoprene Ribbed Belt has certain cold and heat resistance, not only resistant to flexion flex its resistance to aging, ozone resistance than the general unsaturated rubber, and the good oil resistance, solvent resistance and chemical stability, by adding short-fiber reinforcement can withstand higher lateral pressure increase with a wedge pressure resistance, to reduce the force deformation.
EPDM ribbed belts in the resistance to aging is more excellent resistance to ozone aging resistance, weather resistance, heat aging resistance, and electrical insulation properties, resistance to chemical corrosion, the impact of good elasticity (flexibility at low temperatures keep good performance). The company produces rubber Ribbed products, the introduction of foreign advanced technology and production equipment, professional production companies sentinel procurement imports the main raw materials (such as reinforcing materials, rubber, etc.) leading from abroad.
Characteristics of ribbed belts of
Rubber Ribbed both v with peace with the advantages of both, both the flat band of soft, resilient characteristics, and v with compact, efficient. Ribbed main features are as follows: Ribbed belt drives power the same space than ordinary V-belt transmission function and death of 30%. The Ribbed tight transmission system, in the case of the same transmission power, the transfer device share space 25% smaller than common V belts. Ribbed with a thin body, full of flexibility to adapt to the small drive pulley diameter, and high-speed transmission with speed up to 40m / s; vibration, less heat, smooth operation. Ribbed heat resistance, oil resistance, wear resistance, the use of small elongation and long life.
Ribbed purchase Note:
Ribbed belt pulley diameter, wedge slot selection of the appropriate specification model and the wedge number. The Ribbed products Note: Ribbed belt in use piles of oil or water, should be promptly removed or dry; Ribbed Belt packet angle too small, should change the location of the rear pulley to increase the wrap angle; Ribbed belt tension is too small, should be appropriately increase the belt tension; V-ribbed belts in the use of noise:
Ribbed slip arising, should the belt dry; Ribbed Belt wedge slot embedded foreign body, it should be for the belt running protective enclosures; Ribbed Belt pulley is skewed, adjust pulley position; Ribbed products use vibration: Belt tension is too small, should be appropriately increased tension; The Ribbed products to use in the wedge damage:
Ribbed pulley and belt specifications model does not match; Ribbed with a wedge coated with solvents or other chemicals; Ribbed Belt belt use ambient temperature is too high, the cooling method should be improved; Ribbed Belt pulley process parameters do not meet the standards or pulley rusty
