聚合氯化鋁PAC處理后的水鋁含量很低，這也是目前PAC在飲用水處理中最常用的主要因素之一。此外，優質飲用水級PAC使處理后的水更加安全。聚合氯化鋁且腐蝕性較小。在實際生產和使用中，操作簡單，水處理效率高。聚合氯化鋁結合各種特性已成為主s. The main difference is that the quality of PAM is not the same, or the way of adding it is not right, otherwise the product is not matched with the type of wastewater. The quantity of polyacrylamide with good quality is less, and the amount of polyacrylamide with minor addition is slightly more. The specific point is about 1-3 grams. Hohhot City accords with the general municipal wastewater. The industrial wastewater is slightly higher, about 3-6 grams, and the highest 10 grams are also available.
Our answer is only a rough estimate and a budget, but the exact amount should be calculated according to the actual object. The technology will compose 0.1-0.5% solution, and then determine the project dosage in a small scale. Four-thousandths of the 1,200-15 million parts of polyacrylamide wastewater treatment will be compounded with 7-10 grams of monosodium glutamate per ton, layer slag of brewery, wastewater and so on. We can see from the above, in addition to the h
elp of manufacturers to choose polyacrylamide, when using their own, we should pay attention to the use of polyacrylamide. Let's simply remember the following points. Dissolution equipment is required. Concentration should not exceed five thousandths when dissolving. If the equipment is a very simple dissolving pot, we should pay attention to adding 20% of the volume of water in the tank first, then polyacrylamide and water into the tank at the same time, and polyacrylamide should be poured into the tank at a uniform speed, not too much at one time. Otherwise, fish eyes and other phenomena will occur.
我們的回答只是個大概和預算，具體多少還 是要根據具體的實物來測算。技術會配成0.1~0.5%溶液，然后小試確定工程用量，聚丙烯酰胺的污水處理1200-1500萬千分之四配每噸用7-10克味精、啤酒廠 層渣、廢水等。我們從上面看出，除了廠家幫忙選購聚丙烯酰胺，自己在使用時候，要注意聚丙烯酰胺的使用方法。我們只要簡單的記住以 下幾點。要有溶藥設備。在溶解的時候濃度設定不要超過千分之五。如果設備是很簡易的溶藥罐的話，要注意在人工加藥時，要先加20%罐體積的水，然后聚丙烯酰胺和水同時進罐，并且聚丙烯酰胺要勻速的向里面傾倒，不要一次性加的太多。否則會產生魚眼等現象
6O`}2_8C)N@4CU@RV.jpg)
