天通設備水處理污水處理案例參數圖片

工業污水處理工藝基本要求

,工業污水處理是我國工業發展方面一項重頭,工業污水處理關系到我國工業發展,關系經濟民生大計,工業污水處理

1 工業污水處理工藝技術成熟、經濟合理的原則進行總體設計，力求節能降耗、工程投資低、運行成本低、操作管理方便、工藝技術先進成熟的廢水處理工藝流程。

2 工藝流程做到穩定、高效、抗沖擊負荷能力強，運行靈活、設備布置合理結構緊湊;

3 工業污水處理設備選型、匹配得當，運行穩定可靠，性價比高，維護保養簡單，使用壽命長;

鋼廠廢水處理工程概況

該鋼廠形成600萬噸/年生產規模時，平均排水量將達到4000m3/h。廢水處理工程設計平均日處理能力9.6萬米3，夏季最大日處理能力10.8萬米3,其中70%作為工業補水回到廠區管網，其余達標后排放。

  該廢水處理回用工程于2010年4月開工建設，20012年1月主體結構完工，2012年5月試運行，2012年8月交付生產。工程占地29500㎡，新建建、構筑物占地8041㎡，綠化覆蓋率32%，靜態投資為8643萬元。

  廠區全部廢水經處理后達到排放標準，其中回用水經軟化、過濾、消毒等深度處理后，達到生產用水標準。

本工程進水為典型的鋼鐵工業廢水，有機污染物含量不高，可生化性差，不適宜采用生化方法降解。本項目主要采用物理化學法。作為工業補水，在回用水深度處理中增加去除暫時硬度、總堿度軟化、過濾、消毒等工藝。

廠區排出的工業廢水用管道輸送至廢水處理廠進水口。經過預處理部分，用粗、細格柵將來水中較大顆粒的漂浮物去除；再由提升泵到配水構筑物，在此投加混凝劑和石灰以及硫酸，然后將廢水分配到高密度澄清池，除去水中的懸浮物和膠體物質，保證水的澄清度，同時外排水還有除氟工藝。總進水的70%經高密度澄清池處理后，再經V形濾池過濾并投加液氯消毒后，送往廠區作為工業水的補充水，總進水的30%經高密度澄清池處理至達標后排放。 

 濟寧天通設備有限公司是一家從事水處理設備生產、銷售集一體化的企業，經過不斷的努力在國內外獲得了供不應求的大好市場，贏得了客戶的一致好評。

多年的發展歷程，公司始終堅持創新、品質、服務、敬業、感恩的理念。采納新創意，嚴格質量，全方位的服務跟蹤，堅持做出高品質產品。

我公司主要產品：水處理設備，污水處理設備、廢水處理設備、工業污水設備、農業廢水設備、雨水凈水設備、醫院污水設備、鋼廠廢水設備、屠宰場廢水設備、食品廠廢水處理設備等多種設備，可根據要求專業定制水處理設備。

Basic requirements of industrial sewage treatment process

Industrial sewage treatment is an important part of industrial development in China, and industrial sewage treatment is related to industrial development of China, economic and livelihood of the economy, industrial sewage treatment

1 mature industrial wastewater treatment technology, economic and reasonable principle for overall design, makes every effort to saving energy and reducing consumption, lower engineering investment, low running cost, convenient operation and management, advanced and mature technology of wastewater treatment process.

2. The process can be stable, efficient, resilient to impact load, flexible in operation and reasonable structure of equipment layout;

3. Selection of industrial sewage treatment equipment, proper matching, stable and reliable operation, high cost performance, simple maintenance and long service life;

General situation of wastewater treatment project in steel mill

The average displacement of the steel plant will reach 4000m to the third/h when the steel plant is produced at 6 million tons/year. The average daily processing capacity of wastewater treatment works is 96,000 m 3, and the maximum daily processing capacity of the summer is 10.8000m 3. 70% of it is returned to the factory pipe network as industrial rehydration, and the remaining discharge after reaching the standard.

The waste water treatment recycling project started construction in April 2010. The main structure was completed in January, 20012. The trial operation was conducted in May 2012 and the production was delivered in August 2012. The project covers an area of 29500 ㎡, the new building and structures which covers an area of 8041 ㎡, green coverage of 32%, the static investment is 86.43 million yuan.

All waste water in the factory will meet the emission standard after treatment, and the water will reach the standard of production water after softening, filtering and disinfecting.

This engineering water is typical of steel industry wastewater, organic pollutant content is not high, but biochemical difference is not suitable for biodegradation. This project mainly adopts physical chemistry method. As an industrial rehydration, the process of removing temporary hardness, softening of total alkalinity, filtration and disinfection is added in the treatment of water reuse.

The industrial effluent discharged from the factory is piped into the water inlet of the waste water treatment plant. After the pretreatment part, the large particles in the water will be removed by means of coarse and fine grille. By lift pump to the water distribution structures, again in the dosing coagulant and lime and sulfuric acid, and then assigned to high-density clarifier and wastewater to remove the suspended solids in the water and colloidal substances, ensure the clarity of water, drainage and fluoride in process at the same time. 70% of the total water treated with high-density clarifier, then through v-type filtration process and after adding the liquid chlorine disinfection, sent to the factory as make-up water of industrial water, 30% of the total water discharged after high-density clarifier processing to amount to mark.

Jining day general equipment co., LTD. Is a company engaged in water treatment equipment production, sales integration enterprise, after continuous efforts won the demand of the market both at home and abroad, won the customer consistent high praise.

Over the years, the company has always adhered to the concept of innovation, quality, service, dedication and gratitude. Adopt new ideas, strict quality, all-round service tracking, insist on making high-quality products.

My company main products: water treatment equipment, sewage treatment equipment, wastewater treatment, industrial wastewater, agricultural wastewater, rain water purification equipment, hospital sewage equipment, steel plant waste water equipment, slaughterhouse wastewater treatment equipment, food factory waste water treatment equipment and other equipment, can professional custom according to the water treatment equipment.