|
|
Features | |||
![]() |
Functional principle: | Ultrasonic detection principle |
![]() |
![]() |
Fork width: | 3 mm |
![]() |
![]() |
Fork depth: | 69 mm |
![]() |
![]() |
MDO 1) 2): |
Size of labels: 2 mm Gap between labels: 2 mm |
![]() |
![]() |
Label detection: |
![]() |
![]() |
![]() |
Adjustment: | Manual ("+"/"-" button) |
![]() |
![]() |
Output function: | Light/darkswitching, selectable via button |
![]() |
![]() |
1) Minimum detectable object 2) Depends on the label thickness |
![]() |
Mechanics/electronics | |||
![]() |
Supply voltage Vs 1): | DC 10 V ... 30 V |
![]() |
![]() |
Ripple 2): | < 10 % |
![]() |
![]() |
Current consumption 3): | 40 mA |
![]() |
![]() |
Switching frequency 4): | 1,200 Hz |
![]() |
![]() |
Response time 5): | 300 µs |
![]() |
![]() |
Switching output: |
NPN: HIGH = approx. VS / LOW ≤ 2 V PNP: HIGH = VS- ≤ 2 V / LOW approx. 0 V |
![]() |
![]() |
Switching mode: | PNP/NPN |
![]() |
![]() |
Output current Imax. 6): | 100 mA |
![]() |
![]() |
Initialization time: | 100 ms |
![]() |
![]() |
Connection type: | Connector M8, 4-pin |
![]() |
![]() |
Protection class 7): | III |
![]() |
![]() |
Circuit protection: |
Output Q short-circuit protected Interference suppression |
![]() |
![]() |
Enclosure rating: | IP 65 |
![]() |
![]() |
Weight: | Ca. 95 g |
![]() |
![]() |
Housing material: | Aluminum |
![]() |
![]() |
1) Limit values, reverse-polarity protected, operation in short-circuit protected network: max. 8 A 2) May not exceed or fall short of VS tolerances 3)Without load 4) With light/dark ratio 1:1, typical, dependent on material and speed 5) Signal transit time with resistive load 6) Output current minimal 0.03 mA 7) Reference voltage DC 50 V |
![]() |
Ambient data | |||
![]() |
Ambient temperature 1): |
Operation: 5 ... 30 °C Storage: -30 ... 70 °C |
![]() |
![]() |
Shock load: | According to EN 60068-2-27 |
![]() |
![]() |
EMC: | EN 60947-5-2 2) |
![]() |
![]() |
UL File No.: | NRKH.E191603 & NRKH7.E191603 |
![]() |
![]() |
1) Do not bend below 0 °C 2) The UFN complies with the Radio Safety Requirements (EMC) for the indus-trial sector (Radio Safety Class A). It may cause radio interference if used in residential areas. |