力士樂TVD1.3-08-03伺服器顯示F228偏差過大同城快修

F228 Excessive Deviation偏差過大。

Cause:原因：
1. The acceleration ability of the drive was exceeded.
超過了驅動器的加速能力。
2. The motor shaft was blocked.
電機軸堵塞。

3. Parameterization error in the drive parameters.
驅動器參數中的參數化錯誤。
4. "S-0-0159, Monitoring Window" was parameterized incorrectly
“S-0-0159，監控窗口”參數設置錯誤

Remedy:處理措施：
For 1. Check the Bipolar Torque Limit, S-0-0092 parameter and set it equal to the maximum allowable value for the application.
檢查雙極扭矩限制，S-0-0092參數，并將其設置為應用的最大允許值。
For 2. Check the mechanical system and eliminate any jamming of the
motor shaft。檢查機械系統，消除電動機軸
For 3. Check the drive parameters (control loop settings)
檢查驅動器參數（控制回路設置）
For 4. Parameterize "S-0-0159, Monitoring Window"
參數化“S-0-0159，監控窗口”

TVD系列
TVD 1.2-08-03
TVD 1.2-15-03
TVD 1.3-08-03
TVD 1.3-15-03
TVD 1.2-08-03/S100
TVD 1.2-15-03/S100
TVD 1.3-08-03/S100
TVD 1.3-15-03/S100