JHH-08-6C-PT-200船用手動比例流量方向控制閥-錨機操縱閥JHH06-6C-PT-120

WINCH CONTROL VALVE -JHH-06-6C-PT-120

WINCH CONTROL VALVE -JHH-08-6C-PT-200

FEATURES

JHH CONTROL VALVE 3 POSTITON 4DIRECTIONAL SWICHING VALVE WHICH IS COMPOSED OF PRESSURE COMPENSATION DEVICE,FLOW CONTROL VALVE 45 DEGREE TO LEFT AND RIGHT, OIL FLOW FROM P-PORT TO EITHER A OR B-PORT IS PROPORTINALLY CHANGINGACCORDING TO THE OPERATIONAL ANGLE OF LEVER. PRESSURE COMPENSATION DEVICE ISOLATES THE EFFECT OF LOAD CHANGE ANDCONTROL THE SPEED OF ACTUATOR EVENLY.

ORDERING CODE

OPERATIONAL POWER OF LEVER

CONTROL VALVE IS SPOOL VALVE AND THEN THE OPERATIONAL IS A LITTLE BUT THE BRAKE WAS SET FOR THE PREVENTION OFMISOPERATION.THEREFORE, THE LEVER CAN BE KEPT AT RIGHT POSTITON THOUGH THE HAND IS KEPT AWAY.

POSTITON CHANGE OF LEVER

HEAD COVER CAN BE REVOLVED AT RESPECTIVELY 90. PLEASE HANDLE IT AT THE POSTITON TO BE MOST SIMPIY OPERATED.AS FOR THE MEANS OF LEVER POSTITON CHANGE, REMOVE THE LEVERSTOPPER AND ALSO RELEASE FOUR BOLT OFHEADCOVER PART, AND LET IT REWOLVE .

ADJUSTMENT OF FLOW CONTROL WRENCH

THE FLOW OF P.T. PORT BECOME TO AS THE MAXIMUM FLOW AS SHOWN IN THE INDIVIDUAL SPECIFICATION TABLE ANDTHE FLOW FROM A.B. PORT INCREASES IN PROPORTION TO THE LEVER&＃39;S ANGLE AND ON THE OCCASION OF TUMING THECONTROL SCREW TO CLOCKWISE WHEN FLOW CONDITION IS MAXIMUMLY WRENCHED, THE FLOW CAN BE INCREASED AND ITIS DECREASED WHEN THE SCREW IS TURNED TO COUNTERCLOCKWISE.

RELIEF VALVE

THIS RELIEF VALVE IS PILOT TYPE RELIEF VALVE AND MAIN VALVE CAN BE USED BOTH AS PRESSURE SUBSIDIARY VALVE.ON THE OCCASION OF TURNING THE CONTROL SCREW TO CLOCKWISE, THE PRESSURE IS RISEN AND DESCENDED WHEN THESCREW IS TURNED TO COUNTERCLOCKWISE. AND THE RELIEF PRESSURE BECOMES THE DIFFERENTIAL PRESSURE BETWEEN PT. AND ACCORDINALY ON THE OCCASION OF BEING HIGH BACKPRESSURE OF T PORT, THE RELIEF PRESSURE IS MADE HIGHWITH ITS EXTENT.

?

DRAIN

WHEN T PORT&＃39; S PRESSURE BECOMES MORE THEN 70KGF/CM. DRAIN PIPING SHOULD BE FULFILLED AND ON THE OCCASIONOF BEING LESS THAN 70KGF/AM THE INSIDE DRAIN CAN BE USED. LT IS BECOME TO BE AS THE INSIDE DRAIN WITHCLOSING DRAIN PORT.

AIR REMOVAL

LEVER CAN BE MOVED ACCORDING TO PRESSURE&＃39;S CHANGING OF T PORT WHEN INSIDE DRAIN IS USED RELEASE THEPLUG OF HEAD COVER UPPER PART AND PLEASE REMOVE THE AIR.WHEN THE OIL IS NOT FLOWED, IF THE PLUG WAS RELEASED, THE AIR CAN BE PROMPTLY REMOVED, IF THE FRESHFUNCTICNAL OIL IS SUPPLEMENTED. ROTARY ACE VALVE IS UNNECESSARY FOR AIR REMOVAL.